This might be the reason that I am not able to access the Auto button and MPG div fields (grayed out). I had to switch the reset pin function from Reset to Enable Axis (something like that), and I have the e-stop inverted and running open circuit. Since my pendant does not have the redundant "enable" button nor an e-stop, I had to modify some of the setting, and this might be causing some of my problems: Now I have the pendant switching the jog mode on/off by using the axis selector it switches the increment using the increment knob, and it will jog the selected axis with the encoder. I found this manual helped a lot more (which looks like one of his, but not found on his site!?): Pokeys manual does not get into much of any detail, and even his pendant page provides very little. ![]() I only tested a couple of the motor ports and the limit switches. The PoKeys57CNC came in and the basic configuration was complete on a backup PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |